Faculty of Engineering, Built Environment & Design (FEng / FBD): Recent submissions
Now showing items 421-440 of 1463
-
The Interfacial Bond Strength of Sisal- Cement Composites Using A Tensile Test
(Mechanical and Manufacturing Engineering, University of Nairobi, 1982) -
Mesure et Analyse des Champs de Vitesse a’ L’entrée d’un Contact Lubrifie Entre deux Cylindres
(Mechanical and Manufacturing Engineering, University of Nairobi, 1983) -
Overstrain in flush optimal-chamfered cross-bored cylinders
(2006)A three-dimensional finite-element method computer program was developed to establish the elastic—plastic, residual, and service stress distributions in cylinders with flush and non-protruding optimal-chamfered cross-bores ... -
An evaluation of residual stress distribution in welded compact tension specimens using neutron diffraction
(Department of Mechanical Engineering, 2005)The neutron diffraction technique was used to determine the residual stress field in welded compact tension specimens of the aluminium-lithium alloy AA 2095. The deep penetrating characteristic of neutrons was exploited ... -
Stress characterization of autofrettaged thick-walled cylinders
(Department of Mechanical Engingeering, 2003)The inaccessibility of commercial software has necessitated the development of low-cost, general-purpose finite element method (FEM) computer programs for structural analysis. Using the FEM program, the elastic, elastic-plastic, ... -
Staff of the joint services division of eaafro/eavro executive and administration
(Mechanical and Manufacturing Engineering, University of Nairobi, 1976) -
Self-Reliance in Kenya: The Case of Harambee,M.P. Moithi and r. Rasmusson
(Surveying, University of Nairobi, 1979) -
Blooming the Desert: Problems and Alternative Solutions: the Northeastern Province of Kenya
(Surveying, University of Nairobi, 1978) -
The fuelwood problem and the sustainable reproduction of rural life in Mai-ai-ihii Village, Kenya
(Real Estate and Construction Management, University of Nairobi, 1992) -
Novel Solar Cell Technology
(Mechanical and Manufacturing Engineering, University of Nairobi, 2000) -
Materials Science and Device Technology Conference held at University of Nairobi
(Mechanical and Manufacturing Engineering, University of Nairobi, 2000) -
The Value of University-Industry Collaborative Research Case Study – Increase of Electrical Energy Storage Density For Miniaturisation of Implantable Medical Device
(Mechanical and Manufacturing Engineering, University of Nairobi, 2000) -
PLZT Phases Near Lead Zirconate: 2. Determination by Capacitance and Polarization
(Mechanical and Manufacturing Engineering, University of Nairobi, 2006)The phases of PLZT, (Pb,La)(Zr,Ti)O3, or L/Z/T for L<12 and T<10 were detected via determination of capacitance at varying temperatures at 0 field and via polarization at varying fields at room temperature and at selected ... -
The Effect Of Stress Ratio And Frequency On Fatigue Crack Growth
(1979)Fatigue crack growth tests were performed on compact tension specimens (CTS) made in two thicknesses 12 and 24 mm. Tests were conducted at two frequencies of 0·25 and 30 Hz, applying a stress ratio R varying from – 0·7 to ... -
Characterisation and Evaluation of Activated Carbon Produced from Agricultural Wastes in Kenya
(Mechanical and Manufacturing Engineering, University of Nairobi, 2009)